ES2 Background   Building ES2   ES2 Functions



Earthshaker2 Instructions

Busting with ES2: It is only necessary to keep it anywhere for it to bust the heck out of evil energies for a vast distance. I recommend leaving it in the trunk of your car. And occasionally driving around to nasty places with it. Actually, anywhere you go, it will stir up shit.
If you drive slowly, it will bust that area more deeply. If you go over the same area more than once, it will bust deeper each time.
If possible, pause or park near good targets, even if you only have a couple minutes. Electric switching stations, cell towers, dubious churches, Masonic structures, Marriot Hotels, gov't bldgs, ritzy neighborhoods full of Satanists, ritual sites; you know...

TBs: It is generally not that important to expend TBs, etc. into the environment when busting with ES2. Except for lakes, ponds, etc. I use orgone devices that combine the new water-charging program along with the Violet Flame and Strontium-Barium pgms and toss them into bodies of water. Only on rare occasions do i feel moved to put something down by a nasty tower or the like.
Occasionally i will find nasty hot spots of energy where DOR somehow builds up in a spot or two due to ley lines or something, and then i will drop some orgonite.
But you can do awesome busting with ES2 without doing this. It depends on how nasty the area is and how much time you can spend. When i busted Memphis and Knoxville, TN in Jan., 2010, i did invest plenty of strontium orgonite, because i didn't have all day.

Much more cost-effective (Al Gray will probably send you some for free) is Agnihotra ash. If you have some agnihotra ash and sprinkle it judiciously as you go, it can easily make your efforts with ES2 up to 20% more effective. Plus you can park, go inside buildings, and sprinkle some down the drain and here and there inside.

Grid-Blasting: ES2 connects to the electric grid by induction via the scalar qualities of ES2 as well as that of household appliances, etc. (That's as scientifical an explanation as i dare attempt.) It is not needed nor desirable to physically connect it to the electric grid; it will automatically do it.
How well it does this depends mainly on if there's a good energy-exchange item within 10' of ES2. Like an air conditioner, fridge, big transformer, TV, etc. It should connect fully if this is the case.
Keep this in mind when parking overnight.

Or one could take a shop light with a reflector, put it in the trunk within 2 feet of ES2 with the concave side facing ES2, and plug in the cord. Leave it turned off. Bulb not required. This will give 100% grid interface.

Busting the Plumbing: Again, this will pretty much happen by itself if you have ES2 anywhere near water pipes, which are everywhere in urban areas.
You might get a slightly better connection if you run a wire from a cold-water pipe or a water heater, to the unit. Just set the wire on or under the box ES2 is in.

Entourage: I have a whole bunch of allies that are keenly interested in this unit and whatever it kicks up. They will provide some degree of protection and guidance, as well as programming objects in the environment with other good programs that ES2 is not capable of programming into the environment.

ES2 Background   Building ES2   ES2 Functions